syno conversion failed

[suttlew]

I ordered a kit from universal K. and followed the sticky instructions for making prop
at the top of the board. Everything look to be OK until i mixed in the estrogen s.
it almost instantly turned yellow and became thick. I let it sit for 60min and then added 500ml of d. water, and after 15min, of sitting nothing happened, the water was still clear and the solution settled to the bottom. After that i was pretty sure that it was not going to work, so i sturred it up for a couple of min and it start to get a little milkish, then i ran it all through the filter and let it filter overnight and this morning everything had drained through and there was nothing left in the filter.
I think that it was something to do with universal kits, so i am going to order d's kit and try it again, just thought i would see if anyone a some insight on this.
Oh yeah, forgot to mention that the bottle of heat that the kit had in it was only 20-30 ml, and the pellets took overnight to disolve.

[Vladimir]

I am not sure what you used to filter it, but a dust mask is a good choice. Also, from the sounds of it, it looks like you just dumped the pellets in the heet solution to dissolve. Go buy a 5 dollar pill crusher at a grocery store, crush them and you they will disolve in 2-3 hours instead of overnight. And yes, if you are gonna buy a kit, D's kit is a better choice (so they say).

[lakeoffire]

i used the universal kit, it worked fine for me... only complaint on the process is that you should use glass jars for everything because that shit eats the plastic away

[someodd]

I agree with vlad, you should crush your pills!!

Another intresting point- Only 30 ml of heat??? All the instructions I have read, say to use a whole bottle of heat (322 ml). Perhaps that was part of the problem?

Well, better luck next time =)